Vertex Standard FT-950 - MODE-SSB Group

FT-950
Operating Manual
Vertex Standard Co., Ltd.
122
062 RTTY SHIFT
Function: Selects the frequency shift for RTTY (AFSK) operation.
Available Values:170/200/425/850 Hz
Default Setting: 170 Hz
063 RTTY TONE
Function: Selects the Mark tone for RTTY operation.
Available Values: 1275/2125 Hz
Default Setting: 2125 Hz
MODE-SSB Group
064 A3J TX BPF
Function: Selects the audio passband of the DSP modulator on the SSB mode.
Available Values: 1-30/1-29/2-28/3-27/4-26
1-30: 100 ~ 3000 (Hz)
1-29: 100 ~ 2900 (Hz)
2-28: 200 ~ 2800 (Hz)
3-27: 300 ~ 2700 (Hz)
4-26: 400 ~ 2600 (Hz)
Default Setting: 3-27: 300 ~ 2700 (Hz)
Note: the
apparent power output, when using the widest bandwidths, may seem lower.
This is normal, and it occurs because the available transmitter power is distributed
over a wider bandwidth. The greatest compression of power output, conversely, occurs
when using the “4-26” setting (400 ~ 2600 Hz), and this setting is highly recommended
for contest or DX pile-up work.
065 A3J LSB CAR
Function: Adjusts the receiver carrier point for the LSB mode.
Available Values: –200 Hz ~ +200 Hz (10 Hz steps)
Default Setting: 0 Hz
066 A3J USB CAR
Function: Adjusts the receiver carrier point for the USB mode.
Available Values: –200 Hz ~ +200 Hz (10 Hz steps)
Default Setting: 0 Hz