Vertex Standard FT-950 - Display Settings; Display Color, Brightness, and Indicators

FT-950
Operating Manual
Vertex Standard Co., Ltd.
110
003 AGC SLW DLY
Function: Sets the delay time for the AGC SLOW mode.
Available Values: 20 ~ 4000 msec (20 msec/step)
Default Setting: 3000 msec
DISPLAY Group
004 DISP COLOR
Function: Selects the Display color when the optional Data Management Unit
(DMU-2000) is connected.
Available Values: bL1/bL2/bL3/ub1/ub2
bL1: COOL BLUE
bL2: CONTRAST BLUE
bL3: FLASH WHITE
ub1: CONTRAST UMBER
ub2: UMBER
Default Setting: bL1 (COOL BLUE)
Advice: If the optional DMU-2000 Data Management Unit is not connected, this
adjustment has no effect.
005 DISP DIM VFD
Function: Setting of the display brightness level.
Available Values: 0 ~ 7
Default Setting: 4
006 DISP BAR SEL
Function: Selects one of three parameters to be viewed on the Tuning Offset Indicator.
Available Values: CLAr/C-tn/u-tn
Default Setting: C-tn
CLAr: Displays relative clarifier offset.
C-tu: Displays relative tuning offset between the incoming signal and transmitted
frequency while CW operation.
u-tn: Displays the peak position of the optional µ-TUNE filter.
007 DISP PKH S
Function: Selects the peak hold time of the S-meter.