FT-950
Operating Manual
Vertex Standard Co., Ltd.
31
µ-TUNE filter.
28. CLAR
This indicator appears whenever the Clarifier function is activated.
29. MR
This indicator appears when the FT-950 is in the Memory Recall mode.
30. MT
This indicator appears when the FT-950 is in the Memory Tune mode to indicate that
the memory contents have been temporarily changed.
31. Multi-Display Window
This window displays either the Clarifier offset or Memory Channel Number.
Advice:
During FM operation, the Repeater Shift will be indicated in this window. A
Negative frequency shift will be indicated by “–” while a Positive frequency shift
will be indicated by “+.”
When setting the Menu items, the current setting will appear in this area.
When setting the CTCSS frequency for Encoding or Tone Squelch operation, the
current repeater shift direction will appear in this area.
When controlling the optional rotator, the antenna direction will appear in this
area during setup.
Rear Panel
1. ANT 1/2 Jacks
Connect your main antenna(s) here, using a type-M (PL-259) plug and coaxial feedline
for each. The internal antenna tuner affects only the antenna(s) connected here, and
only during transmission.
2. DC IN Jack
This is the DC power supply connection for the transceiver. Use the supplied DC cable
to connect directly to a DC power supply, which must be capable of suppling at least 22
A @13.8 VDC.
To Next Page
Loading...
Need help?
General
