FT-950
Operating Manual
Vertex Standard Co., Ltd.
3
Interfacing for digital modes is extremely simple with the FT-950, thanks to dedicated
RTTY/PKT connection jack on the rear panel. Optimization of the filter passbands,
DSP settings, carrier insertion point, and display offset are all possible via the Menu
programming system.
The Yaesu CAT system provides a direct link to the transceiver CPU for computer
control and customization of tuning, scanning, and other operating functions. The
FT-950 includes a built-in data level converter for direction connection to a personal
computer serial port. Yaesu products are supported by most all of the leading contest
and DX logging programs, and the extensive programming protocol is included in this
manual, if you wish to write your own software!
Advanced technology is only part of the FT-950 story. Vertex Standard stands behind
our products with a worldwide network of dealers and service centers. We greatly
appreciate your investment in the FT-950, and we look forward to helping you get the
most out of your new transceiver. Please feel free to contact your nearest dealer, or one
of Vertex Standard’s national headquarters offices, for technical advice, interfacing
assistance, or accessory recommendation. And watch Vertex Standard U.S.A.’s Home
Page for late-breaking information about Vertex, Standard Horizon, and Yaesu
products: http://www.vertexstandard.com.
Please read this manual thoroughly, so as to gain maximum understanding of the full
capability of the FT-950, and we thank you again for your purchase!
Table of Contents
General Description 1
Accessories & Options 4
Supplied Accessories 4
Available Options 4
Before You Begin 5
Connecting AC Power 5
AC Input Voltage Selection 5
Extending the Front Feet 6
Adjusting the Main Tuning Dial Torque 6
Resetting the Microprocessor 7
To Next Page
Loading...
Need help?
General
