FT-950
Operating Manual
Vertex Standard Co., Ltd.
117
Default Setting: Ur
When this menu is set to “Ur”, you may adjust the microphone gain using the front
panel’s [MIC GAIN] knob.
MODE-CW Group
037 A1A F-TYPE
Function: Selects the desired keyer operation mode for the device connected to the
front panel’s KEY jack.
Available Values: OFF/buG/ELE/ACS
Default Setting: ELE
OFF: Disables the front panel’s keyer (“straight key” mode for use with external
keyer or computer-driven keying interface).
buG: Mechanical “bug” keyer emulation. One paddle produces “dits” automatically,
while the other paddle manually produces “dahs”.
ELE: Iambic keyer with ACS (Automatic Character Spacing) disabled.
ACS: Iambic keyer with ACS (Automatic Character Spacing) enabled.
038 A1A F-REV
Function: Selects the keyer paddle’s wiring configuration for the KEY jack on the front
panel.
Available Values: nor/rEV
Default Setting: nor
nor: Tip = Dot, Ring = Dash, Shaft = Ground
rEV: Tip = Dash, Ring = Dot, Shaft = Ground
039 A1A R-TYPE
Function: Selects the desired keyer operation mode for the device connected to the rear
panel’s KEY jack.
Available Values: OFF/buG/ELE/ACS
Default Setting: ELE
OFF: Disables the front panel’s keyer (“straight key” mode for use with external
keyer or computer-driven keying interface).
buG: Mechanical “bug” keyer emulation. One paddle produces “dits” automatically,
while the other paddle manually produces “dahs”.
ELE: Iambic keyer with ACS (Automatic Character Spacing) disabled.
To Next Page