FT-950
Operating Manual
Vertex Standard Co., Ltd.
90
021 KEY CW MEM3
022 KEY CW MEM4
023 KEY CW MEM5
Advice: Press the [SELECT] knob to toggle the Menu item display between “Menu
Item Number & Group Name” and “Menu Function”.
3. Rotate the [CLAR/VFO-B] knob to set the selected CW Memory Register to “tyP2.”
If you want to text message entry on all memories, set all five Menu items (#019 ~
023) to “tyP2.”
4. Press and hold in the [MENU] button for two seconds to save the new settings and
exit.
Message Memory Programming (Using Your Paddle)
1. Set the operating mode to CW.
2. Set the [BK-IN] button to “Off”.
3. Turn the internal Electronic Keyer “On” by pressing the [KEYER] button, if
necessary.
4. Press the [MEM] key on the FH-2. A blinking “REC” icon will appear in the
display.
5. Press any of the FH-2’s keys numbered [1] through [5] to begin the memory
storage process, and the “REC” icon will glow steadily.
6. Send the desired message using your keyer paddle.
Advice: If you do not keying within ten seconds, the memory storage process will
be cancelled.
7. Press the [MEM] key on the FH-2 once more at the end of your message. Up to 50
characters may be stored among the five memories.
Note: you must exercise care in sending to ensure that the spaces between letters
and words are accurately done; if your timing is off, the spacing may not come out
right in the stored message.
For ease in setting up the keyer memories, we recommend you set Menu item “037
A1A F-TYPE” and/or “039 A1A R-TYPE” to “ACS” (Automatic Character Spacing)
while you are programming the keyer memories.
Checking the CW Memory Contents
1. Be sure that Break-in is still turned “Off” by the [BK-IN] button.
2. Press the [MONI] button to enable the CW monitor. A “MONI” icon will appear in
the display.
To Next Page
Loading...
Need help?
General
