Vertex Standard FT-950 - Tuning Group; Tuning Speed and µ-TUNE Modes; Scanner Settings and Mic Control

FT-950
Operating Manual
Vertex Standard Co., Ltd.
115
027 GENE CAT TOT
Function: Sets the Time-Out Timer countdown time for a CAT command input.
Available Values: 10/100/1000/3000 msec
Default Setting: 10 msec
The Time-Out Timer shuts off the CAT data input after the continuous transmission of
the programmed time.
028 GENE CAT RTS
Function: Enables/Disables the RTS port of the CAT jack.
Available Values: On/OFF
Default Setting: OFF
029 GENE MEM GRP
Function: Enables/Disables Memory Group Operation.
Available Values: On/OFF
Default Setting: OFF
030 GENE Q SPLIT
Function: Selects the tuning offset for the Quick Split feature.
Available Values: –20 ~ 0 ~ +20 kHz (1 kHz Step)
Default Setting: +5 kHz
031 GENE TX TOT
Function: Sets the Time-Out Timer countdown time.
Available Values: OFF/5/10/15/20/25/30 min
Default Setting: OFF
The Time-Out Timer shuts off the transmitter after continuous transmission of the
programmed time.
032 GENE uT DIAL
Function: Selects the µ-TUNE mode.
Available Values: StP1/ StP2/OFF
Default Setting: StP1
StP-1: Activates the µ-TUNE system using “COARSE” steps of the
[SELECT(µ-TUNE)] knob (2 steps/click) on the 7 MHz and lower amateur