FT-950
Operating Manual
Vertex Standard Co., Ltd.
92
Item Number & Group Name” and “Menu Function”.
3. Rotate the [CLAR/VFO-B] knob to set the selected CW Memory Register to “tyP1.”
If you want to text message entry on all memories, set all five Menu items (#019 ~
023) to “tyP1.”
4. Press and hold in the [MENU] button for two seconds to save the new settings and
exit.
Text Message Programming
1. Press the [CW] button to set the operating mode to CW.
2. Be sure that Break-in is “Off” by pressing the [BK-IN] button, if necessary.
3. Press the FH-2’s [MEM] key. A blinking “REC” icon will appear in the display.
4. Press the FH-2’s [1] ~ [5] key to select the desired CW Memory Register into which
you wish to program the text, the “REC” icon will glow steadily.
5. Use the FH-2’s [W] and [X] keys to set the cursor position and use the FH-2’s [S]
and [T] keys to choose the letter/number to be programmed in each slot of the
memory. In the case of the second example above, the “#” character designates the
slot where the Contest Number will appear.
Advice: You may also use the Main Tuning Dial knob and the [CLAR/VFO-B] knobs
to program the message characters.
6. When the message is complete, add the “}” character at the end to signify the
termination of the message.
7. Press and hold in the FH-2’s [MEM] key for two seconds to exit, once all characters
(including “}”) have been programmed.
Advice:
Deleting Previously-stored Characters
Use the FH-2’s [W] and [X] keys or Main Tuning Dial knob to select the last correct
letter in the message. Now use the FH-2’s [S] and [T] keys or rotate the
[CLAR/VFO-B] knob to select the “}” character; everything after the “}” character will
be deleted.
Checking the CW Memory Contents
1. Be sure that the Break-in is still turned “Off” by the [BK-IN] key.
2. Press the [MONI] button to enable the CW monitor. A “MONI” icon will appear in
the display.
3. Press the FH-2’s [1] ~ [5] key whichever one you just recorded in. A “PLAY” icon
To Next Page
Loading...
