VXA-210 PILOT OPERATING MANUAL
10
low the appropriate instructions provided with
the charger/battery. Contact your Dealer if you
have any doubts about the appropriateness of the
particular charger or battery pack you intend to
use.
BEFORE YOU BEGIN
Battery Charging
It is necessary to fully charge the Ni-Cd battery be-
fore its first use. Follow these procedures:
¦ Install the supplied FNB-64 Ni-Cd battery pack
onto the transceiver. Ensure that the transceiver
is switched off.
¦ Plug the NC-77 into the AC line outlet.
¦ Insert the transceiver and battery pack into the
NC-77; the antenna jack should be at the left
side when viewing the charger from the front.
¦ If the transceiver and battery pack are inserted
correctly, the RED indicator will glow. A fully-
discharged pack will be charged completely in
10 hours.
Important Notes:
r The NC-77 is not designed to power the trans-
ceiver for operation (reception or transmission).
r Do not leave the charger connected to the trans-
ceiver for continuous periods in excess of 24
hours. Long term overcharging can degrade the
Ni-Cd battery pack and significantly shorten its
useful life.
r If using a charger other than the NC-77, or if
using a battery pack other than the FNB-64, fol-
VXA-210/NC-77
1
4
7
To Next Page
Loading...
Need help?
General
