To setup the network for a MAC:
1. Click the System Preferences icon on the Dock, and choose Network.
Figure 3.5 MAC System Preferences
2. Ensure Ethernet is highlighted on the left side of the NIC window. In most cases, there will be
one Ethernet entry on a Mac. Write down the current settings so you can restore them to
normal after you have completed the setup procedure.
3. Select Manually from the Configure IPv4 drop-down list, then set IP Address to 192.168.123.1
and Subnet Mask to 255.255.255.0 and click Apply.
NOTE: The Router and DNS Server settings can be left blank for this initial setup.In a web browser,
enter http://192.168.123.123 to access the unit. If you are setting up the unit for the first time, or if the
unit has been reset back to factory defaults via the network-reset button, the unit requires you to
create an Admin account and password before you can proceed.
4. After the admin account is created, log in to the unit.
Vertiv | Intelligent Rack PDU Installer/User Guide
24
To Next Page
Loading...
Need help?
General
