The Users section allows you to configure the various Read, Write, and Trap communities for SNMP
services. You can also configure the authentication types and encryption methods used for the SNMP v3
if desired. Click the modify icon to change settings.
Traps allows you to define the IP addresses and SNMP types that you wish the traps to be sent.
To configure a trap destination:
1. Locate the Traps section of the SNMP page, and click the Add icon.
2. Enter the IP Address which the trap should be sent to in the Host field.
3. Change the Port number if required.
4. Select the trap version to be used (v1, v2c or v3) and click Save.
A test trap may be sent by clicking on the test icon next to the Host IP address. Trap settings can also be
updated/changed by clicking the modify icon next to the Host IP address.
SYSLOG
Syslog data can be captured remotely but must first be setup and enabled via the Syslog page.
NOTE: This function is primarily only useful for diagnostic purposes, and should normally be left
disabled unless advised to enable it by Vertiv technical support for troubleshooting a specific issue.
Admin
The Admin page allows the administrator of the device to save their contact information along with the de
vice description and location. Once the info is saved by an administrator, other (non-administrator) users
can view the information. Also, the System Label can be modified on this page. This label is typically shown
in the title bar of the web browser's window, and/or on the browser tab(s) currently viewing the device.
Locale
The Locale page sets the default language and temperature units for the device. These settings will
become the default viewing options for the device, although individual users can change these options for
their own accounts. The guest account will only be able to view the device with the options set here.
Utilities
The Utilities page in the System menu provides the ability to restore defaults, reboot the communication
system and perform firmware updates.
The Restore Defaults section allows you to restore the unit's settings to the factory defaults. There are two
options:
• All Settings: Erases all of the unit's settings, including all network and user accounts settings,
effectively reverting the entire unit back to its original out-of-the-box state.
• All Non-Network Settings: Erases all settings except the Network and User Accounts.
Vertiv | Intelligent Rack PDU Installer/User Guide
46
To Next Page
Loading...
Need help?
General
