2. Enter the email address and then click Save.
To delete a target email address:
1. Click the delete icon next to the address you wish to delete.
2. Click delete on the pop-up window to confirm.
To send a test email:
1. Click the test email icon next to the address you wish to test.
2. A pop-up window indicates the test email is being sent, click OK to dismiss the pop-up.
SNMP
Simple Network Management Protocol (SNMP) can be used to monitor the unit's measurements and
status, if desired. SNMP v1, v2c and v3 are supported. In addition, alarm traps can be sent to up to two IP
addresses.
Figure 3.20 SNMP Configuration Page
The SNMP-V1/V2c and SNMP-V3 Service can be enabled or disabled independently as desired. The
service listens for data-read requests on port 161, which is the usual default for SNMP services; this can
also be changed if desired.
The Management Information Base (MIB) can be downloaded from the unit, if needed, via the MIB link at
the top of the web page. Clicking this link downloads a .zip archive containing both the MIB file itself, and a
CSV-formatted spreadsheet describing the available OIDs in a human-readable form to assist you in
setting up your SNMP manager to read data from the unit.
Figure 3.21 SNMP Users Configuration Page
3 Setup
45
To Next Page
Loading...
Need help?
General
