Vertiv Netsure User Manual

NetSure
™
Control Unit (NCU)
User Manual, UM1M830BNA
Spec. No: 1M830BNA, 1M830DNA Code: UM1M830BNA
Model No: M830B, M830D Revision M, May 12, 2017
[149]
NMSV3 Configuration Description (Network Management System)
Configures SNMP Version 3 parameters.
You can configure the following parameters.
 Use Name: The permitted User to access the NMSV3 agent.
 Priv Password DES: The privacy DES password used to encrypt the data.
 Auth Password MD5: The authorization MD5 password used to encrypt the digital signature.
 Trap Enabled: Trap function enabled or disabled.
 Trap IP: The IP to which the trap is sent. Check the IPV6 box when entering an IPV6 trap address.
 Trap Security Level: The SNMP v3 data security level (NoAuthNoPriv, AuthNoPriv, or AuthPriv).
o NoAuthNoPriv: SNMP messages are sent without authentication and without privacy.
o AuthNoPriv: SNMP messages are sent with authentication but without privacy.
o AuthPriv: SNMP messages are sent with authentication and with privacy.
NOTE: For SNMP v3, the security level for Get and Set operations is set to “AuthPriv” and cannot be adjusted.
NOTE: Controller must be reset after configuration of initial SNMP v3 User (Advanced Settings Menu / SW Maintenance Tab / Restore
Factory Defaults / Reboot Controller).
Figure 79. SNMP - NMSV3 Configuration
Check the IPV6
box when
entering an IPV6
trap address.

Vertiv Netsure Specifications

General

Brand	Vertiv
Series	Netsure
Humidity Range	5% to 95% non-condensing
Cooling Method	Forced air
Communication Interface	Ethernet
Protection Features	Overvoltage, overcurrent, short circuit, overtemperature