Vetaphone iPM200-5 - Page 36

iPM 200 generator module
® Vetaphone March 2021 3401201GB
Page 36 of 52
E – 17
Self-test (Power Stage
error)
(Only exists in Firmware version
5.21 and up)
if this error persists the generator is defect, contact support
department
E – 18
Power unit error.
Generator defect. Contact the support department
E – 19
Mains overload
This error can occur due to high surge or burst pulses on the
mains supply lines.
Reset the error and wait 10 seconds and try again.
If the error persists, contact the support department
E - 200
Power limit exceeded
Clean insulators and electrode and adjust electrode.
Can also be caused by a flash over or defective cable (check
cables)
Reset the error and wait 10 seconds and try again.
If the error persists, contact the support department
E – 21
Mains tolerance error
Check input supply voltage are within range 380-520Vac
E – 22
The output power has been
lower than minimum limit
for more than 3 seconds.
Reset the error, if the error persists contact the support
department.
E - 30
Too low feedback signal
Clean electrode and insulators, 80% of E-30 errors are
caused by this. Check for flashover, flame or electrode
adjustment.
For electrode adjustment, see station manual.
E – 37
Custom Error.
This is a customer specific error code and mean different
things.
The codes meaning is determent in agreement with the
customer.
E – 38
Custom Error.
This is a customer specific error code and means different
things.
The codes meaning is determent in agreement with the
customer.
E – 39
Custom Error.
This is a customer specific error code and means different
things.
The codes meaning is determent in agreement with the
customer.
E – 40
Custom Error.
This is a customer specific error code and can mean different
things.
Typically, the error code shows cartridge is missing/not
detected when cartridge sensors (dummy cartridge) are
installed. Check the distance between sensor and cartridge
(should be 1 mm).
The code meaning is determent in agreement with the
customer.
If the error persists, contact the support department.