Vetaphone iPM200-5 - Page 46

iPM 200 generator module
® Vetaphone March 2021 3401201GB
Page 46 of 52
Station is not closed
Close the station and make sure that the
cartridge on the station are closed.
No air flow
Check that the extraction fan works and that
there is airflow through the station.
If the generator controls the extraction fan,
the generator will flash "stand by" in the ON-
button until the airflow is correct. When the
problem is solved the generator automatically
starts up again.
Check rotation of the fan.
Communication error
Check the cable between the remote control
and generator.
Roller not rotating
The minimum speed of the line is not
reached or the rotation sensor is not in
correct position.