The setup is over, Please close the Mach software that all data setup can be available. And then open it
again to check whether all the data is correct otherwise can’t run your machine well.
3. Try to use your CNC
1. First let us to learn this machine, below take 3020 for example, The full kit has the machine(the
Frame), the electrical control box, X,Y,Z stepper motors, the spindle and the spare parts box(it contains
the 4 pcs presser feet, 5 pcs test bits, 1 pair of spare carbon brush, 1 pcs fuse pipe,ancethe spanner of
the spindle, the 6 hexagonal spanner and the nuts and screws).
To Next Page
Loading...
