VIA Technologies VAB-820 - Page 17

VAB-820 Linux BSP v3.2.0 Quick Start Guide
12
To set the AUO 10.4” G104XVN01.0 LVDS panel as the display output, use the
following command:
=> run o_lvdsg104
=> saveenv
In order to confirm the settings are correct use the following command to list the new
U-Boot parameters:
=> printenv lvds_auo_g104
lvds_auo_g104=video=mxcfb0:dev=ldb,LDB-XGA, if=RGB24 ldb=sin0
To set the AUO 7” G070VW01 V0 LVDS panel as the display output, use the following
command:
=> run o_lvdsg070
=> saveenv
In order to confirm the settings are correct use the following command to list the new
U-Boot parameters:
=> printenv lvds_auo_g070
lvds_auo_g070=video=mxcfb0:dev=ldb,480C60,if=RGB24 ldb=sep0