VIA Technologies VAB-820 - Getting Started: Introduction; Package Contents Overview; BSP Folder Contents; Document Folder Contents

VAB-820 Linux BSP v3.2.0 Quick Start Guide
1
1. Introduction
The purpose of this document is to provide an overview of getting started with the
VAB-820 board using Yocto with an OpenEmbedded filesystem.
The VAB-820 Linux BSP v3.0.2 is developed based on the NXP fsl-yocto-3.14.28_1.0.0
(Yocto 1.7 Dizzy) and enables hardware features that are defined on the VAB-820 board.
1.1. Package Contents
There are three folders in the package as listed below.
BSP folder Description
VIA_iMX_Yocto1.7_SRC_v3.2.0.tar.bz2
Source code
Document folder Description
VAB-820_Linux_BSP_v3.2.0_Quick_Start_Guide
_v1.00_20161220.pdf
Quick Start Guide
VAB-820_Linux_EVK_v3.2.0_Image_Installation
_Guide_v1.00_20161220.pdf
Image Installation Guide
EVK folder Description
via-image-gui-imx6qvab820.sdcard
SD card image
u-boot.imx
U-Boot boot loader
zImage
Kernel
zImage-imx6q-vab820.dtb
Device tree
modules-imx6qvab820.tgz
All module drivers
BT_Config folder
Bluetooth configuring files
VAB-820 Linux BSP contents
1.1.1. BSP Folder Contents
VIA_iMX_Yocto1.7_SRC_v3.2.0.tar.bz2:
A complete and static Yocto BSP including the
VAB-820 meta-files and all the pre-downloaded required software packages to enable a
complete offline build.
1.1.2. Document Folder Contents
VAB-820_Linux_BSP_v3.2.0_Quick_Start_Guide _v1.00_20161220.pdf:
The Quick Start
Guide provides an overview of getting started with the VAB-820 system using Yocto
with an OpenEmbedded filesystem.
VAB-820_Linux_EVK_v3.2.0_Image_Installation_Guide_v1.00_20161220.pdf:
The Image
Installation Guide explains how to boot the Linux EVK system image on the VAB-820
system in order to begin evaluating the platform.