Vibra AJ-E Series - Operation for Tare Subtraction

10
3.3 Operation for Tare Subtraction
1 Place the tare (container) on the balance.
0・| | | F

g
As you place the tare, the balance
indicates its weight.
2 Reset read-out indication to zero.
→0←→T← 0・| | | F

 g
Press the Zero/Tare key.
The tare is subtracted and the
balance indicates zero.
3 Load the sample to be weighed.
→T← 0・|・| |
F

 
g
The balance will now indicate only
the weight of the sample loaded in
the tare.
☆ Weighing only the weight of an added sample
4 Resetting the indication to zero
→0←→T← 0・|・| | F

   g
Press the Zero/Tare key.
The total weight of the sample loaded
on the measurement pan is indicated
as zero.
5 Adding samples to be measured
→T← 0・|・|・|
F

 
g
The balance indicates only the
weight of an added sample.
When the weight (of a sample)
currently loaded on the
measurement pan is reset to zero
with the Zero/Tare key, as
mentioned above, only the weight of
the sample will be measured.