13
4.2 Description of Functions
Item Set Value Description
Disable
Bar graph display
☆
Enable
☆
Disable
Limit function
Enable
☆
Always judge (judges even when the balance is unstable)
Judgement
condition
Judge only when the balance is stable (does not judge
if the balance is unstable)
Ranges beyond +5 graduation is judged (ranges +5
graduation or below, including negative ranges, are not
judged.)
Judgement
range
☆
The entire range is judged (the entire range, including
the negative, is judged).
One-point setup (judges between OK and LO)
Displayed only when limit
function is activated
Number of
points for
judgement
☆
Upper-limit and lower-limit values are set up (judges
among HI, OK and LO).
Disable
Auto-zero
(zero-tracking)
☆
Enable
This function automatically sets the zero point
exactly to zero to prevent slight deviations.
Disable (balance operates
continuously)
Auto power-off
☆
Enable (balance powers off in
approximately three minutes)
This function is
available only when
the balance is
battery-operated.
Measurement by consecutive weighings.
☆
Response speed
Fast
↓
Slow
☆
Stability parameters
Wide (mild)
↓
Narrow (strict)
Disable input/output
☆
Six-digit numeric format
Interface
Seven-digit numeric format
☆1
[ g ]
☆2
[ ] (ct)
[ ] (oz)
[ ] (lb)
[ ] (ozt)
[ ] (dwt)
Setup of units of
measurement to be
displayed
Register selected
measuring units with
Function key.
[
Lower right ] (grain)
Items marked ☆ are the default factory settings.
☆1〜☆5: default settings [
]〜[
]
To Next Page
Loading...
