Vicon Extra 832T PRO - Page 128

Maintenance
128
If the cutterbar is not horizontal, carry out the following:
 Raise or lower the tractor's lift arms until the cutterbar is horizontal.
 Remove the oilplug.
 Fill up with the new oil until the oil level is as shown.
• Min. 6 mm (
1
/
4
’’)
• Max. 9 mm (
3
/
8
’’)
 »Lubricants« page 170
 Fit and tighten up the oilplug.
 Open the mechanical safety valve.
Model Litre
(approx.)
Pints (US)
(approx.)
Pints (Imp.)
(Approx.)
828T Pro 3.6 7.6 6.3
832T-CT Pro 4.1 8.6 7.2
835T-CT Pro 4.6 9.7 8.1
Valve