PAGE 20 of 36 VR GSM DOOR INTERCOM TECHNICAL MANUAL VER2.0.0
1111SPTnn? Store the time nn x 20 seconds (e.g. nn = 02, time = 40
seconds. Also send a confirmation text back to the
sender.
1111SPT? Query the current stored time. A text message will be
sent to the sender showing the stored time. (Remember
to multiple the number in the received text by 20
seconds)
SET RELAY TIME
The relay time can be from 01 – 99 seconds or latching (Set the relay time to 00 for
latched mode. In latch mode, the relay will stay energised until the command is send
again).
1111RLTnn Store the time nn = time in seconds.
1111RLTnn? Store the time nn = time in seconds. Also send a
confirmation text back to the sender.
1111RLT? Query the current stored time. A text message will be
sent to the sender showing the stored time.
SET AO (AUXILIARY OUTPUT) TIME (FOR AOM = 01 ONLY)
The AO time can be from 01 – 99 seconds or latching (Set the AO time to 00 for latched
mode).
1111AOTnn Store the time nn = time in seconds.
1111AOTnn? Store the time nn = time in seconds. Also send a
confirmation text back to the sender.
1111AOT? Query the current stored time. A text message will be
sent to the sender showing the stored time.
SET AO (AUXILIARY OUTPUT) MODE
There are two mode of operation for the AO terminal:-
User activated: nn = 01
To activate the AO terminal either short AI to C1 or press 6 on the telephone during a call.
Call activated: nn = 00
AO will activate when a call begins and deactivate when the call ends.
1111AOMnn Store the mode nn = 01 or 00.
1111AOMnn? Store the mode nn = 01 or 00. Also send a confirmation
text back to the sender.
To Next Page
Loading...
Need help?
General
