PAGE 21 of 36 VR GSM DOOR INTERCOM TECHNICAL MANUAL VER2.0.0
1111AOM? Query the current stored mode. A text message will be
sent to the sender showing the stored mode.
CHANGING THE FOUR DIGIT CODE
The four digit code can be any combination of numbers 0-9 but must be 4 digits long. The
code allows access to the programming menu in dial in mode and must be used when
sending text messages to the intercom panel. The following message changes the code:-
1111CDEnnnn nnnn = new 4 digit code
SET DAYS TO WAIT BEFORE MAKING A CALL
In the event the intercom panel is not used for long periods of time it could be possible that
the network disconnects it. To prevent this from happening it is possible to program a time
period (From 01 – 99 days) to wait before the intercom panel makes a short call to refresh
the connection. This time period is reset after each call made on the system and will only
happen if the full time period elapses without any incoming or outgoing calls.
1111NODnn Store the time nn = time in days.
1111NODnn? Store the time nn = time in days. Also send a
confirmation text back to the sender.
1111NOD? Query the current stored time. A text message will be
sent to the sender showing the stored time.
DIVERT TIME
The divert time is the number of seconds to wait for a call to be answered before diverting
to the second number (The divert facility must be set for this to work). The default time is
15 seconds (The count down begins from when the call button is pressed, but is refreshed
when the telephone begins to ring) and can be set to 01 – 99 seconds).
1111DITnn Store the time nn = time in seconds.
1111DITnn? Store the time nn = time in seconds. Also send a
confirmation text back to the sender.
1111DIT? Query the current stored time. A text message will be
sent to the sender showing the stored time.
To Next Page
Loading...
Need help?
General
