67
1. Hold down MODE and simulta-
neously for approx. 5 s.
■
"SEt" and flash
■ "PL:1" is shown on the additional
display
■
is shown in the upper display
area
2. Press MODE.
3. Use / to select "P10".
4. OK to confirm
5. Use / to select the access code
for parameter level 2.
6. OK to confirm
■ "PL:2" is shown on the additional
display.
■
is shown in the upper display
area.
7. MODE to confirm
8. Use / to select the parameter.
9. OK to confirm
Stopping DHW heating
Parameter Setting Function
"P13" "OFF" DHW heating switched on
"On" DHW heating switched off
External temperature sensor (room temperature sensor/outside temperature
sensor)
Parameter Setting Function
"P14" "OFF" Without temperature sensor
"OTC"/"OTC" With outside temperature sensor
"RTC"/"RTC" With room temperature sensor
External extension
Parameter Setting Function
"P27" "OFF" Without external extension
"On" With external extension
"P40" to
"P49"
See installation and service instructions for the external extension
Parameter
Parameter level 2
5837146
Service
To Next Page
Loading...
