Viking VDSC536 - Burner Base and Side Panel Removal

Disassembly
44 ©2009 Viking Preferred Service
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.
Burner Base Assembly Removal
Condition Requirements:
None
1. Remove grates, burner cap, and burner head from
burner base assembly.
2. Remove two screws and lift burner base assembly
from range.
3. Disconnect wire from burner base assembly.
4. Reverse procedure for installation.
Side Trim and Side Panel Removal
Condition Requirements:
Control Panel Assembly Removed
Island Trim or Backguard Assembly Removed
1. Remove two screws and lift kick plate from keyhole
screws.
2. Remove two screws and side trim from range.
3. Remove screw and side trim support from range.
4. Remove four screws and side panel from range.
5. Reverse procedure for installation.
Hinge Receiver Removal
Condition Requirements:
Door Assembly Removed
Side Panel Removed
1. Remove three screws and side trim from range.
2. Remove fi ve screws and panel from range.