Viking VGSC548 - 48 LH Oven;Griddle Control Removal; 30, 36, 48 RH Oven Function Selector Removal; 30, 36 and 48 RH Oven Thermostat Removal; Door Latch Assembly Removal

Disassembly
©2010 Viking Preferred Service 31
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.
48" LH Oven/Griddle Control Removal
Condition Requirements:
Control Components Accessed
1. Mark and disconnect connectors from the oven
control.
2. Remove two screws, bezel, and the oven control
from the control panel assembly.
3. Reverse procedure for installation.
30", 36" and 48" RH Oven Function
Selector Removal
Condition Requirements:
Control Components Accessed
1. Disconnect connector from the oven function
selector.
2. Remove two screws, bezel, and the oven function
selector from the control panel assembly.
3. Reverse procedure for installation.
30", 36" and 48" RH Oven
Thermostat Removal
Condition Requirements:
Control Components Accessed
1. Disconnect connector from the oven thermostat.
2. Remove two screws, bezel, and the oven thermostat
from the control panel assembly.
3. Reverse procedure for installation.
Door Latch Assembly Removal
Condition Requirements:
Control Components Accessed
1. Remove screws and slide component tray forward.
Note: VGSC530 shown. Other component tray
configurations may be different on other models.
2. Mark and disconnect wires from door latch assembly.
3. Remove two screws and door latch assembly from
component tray.
4. Reverse procedure for installation.