11
7509 - 7509/D Tab
EN
Installer configurations
The basic entryphone configurations are as follows:
- ID code configuration, which must be be performed on the entryphone receiving the call individually or on the first
indoor station of a group of indoor stations with simultaneous calls (master entryphone/video entryphone).
- Secondary ID configuration , to be performed for entryphones associated with a master indoor station.
- Configuration of the programmable buttons or changing the default settings of additional buttons, for auxiliary
services or intercom calls.
The congurations must be performed with the system switched on, without active communication and only after
connecting the indoor stations to the system and after conguring the outdoor stations.
Caution!: all the conguration or deletion phases must be performed with the entryphone handset lifted and
held against the user’s ear.
The device can be congured in the following ways:
• “Simplied” conguration mode via the indoor station buttons.
N.B.: This conguration mode is available from rmware version 1.06 (also after update).
• “Standard” conguration mode via the indoor station buttons.
• Conguration via the “SaveProg” software of the Due Fili Plus system.
N.B.: ID conguration is only performed from the indoor station, and is not available via the SaveProg software.
To Next Page
Loading...
Need help?
General
