Vimar Elvox 7509 - Configure Self-start Button

20
7509 - 7509/D Tab
EN
Configuration of a button for self-starting a specific outdoor station ( , , , , )
(different from the self-start function enabled using button )
Conguration procedure (“Simplied” mode):
Raise the handset and bring it to your ear to listen to the sound feedback emitted by the entryphone during
the conguration phase.
1. Press the button to be congured and hold it down for at least 6 s.
2. When the indoor station has emitted a “beep”, release the button to congured.
3. In the outdoor station you wish to congure the self-start, press the call button corresponding to the indoor station
being congured. (*)
4. A high tone conrms the end of the procedure. The indoor station will be called by the outdoor station concerned.
2 3 4
< 60 s
beep
**
beep
1
> 6 s
*
Conguration procedure in “Standard” mode
1. Lift the handset and bring it to your ear.
2. Press the
and buttons simultaneously and hold them down until the button starts flashing.
3. Release buttons
and .
4. Press and hold down the button to be configured.
5. Wait until the entryphone handset emits an audible signal.
6. Release the button.
7. In the outdoor station you wish to configure the self-start, press the call button corresponding to the indoor station
being configured. (*)
8. At the end of the procedure described above, the entryphone handset emits an audible signal to indicate that the
procedure has been completed correctly.