13
7509 - 7509/D Tab
EN
Conguration procedure in “Standard” mode
1. Lift the handset and bring it to your ear.
2. Press the
and buttons simultaneously and hold them down until the button starts flashing.
3. Release the buttons.
4. Press button
and hold it down (for 2 s) until the handset emits an audible signal and communication between
the entryphone and the MASTER outdoor station begins.
5. Release the button
.
Caution: you will have 5s in which to press button
(as indicated in step 4). If button is not pressed within
the 5s, steps 1, 2 and 3 must be repeated.
6. Press the button on the MASTER outdoor station you wish to receive the call from. (*)
7. The ID code is associated with the indoor station and communication is ended. An acoustic signal conrms the
operation was successful. (**)
N.B. (*): This procedure applies to entrance panels with push buttons; for alphanumerical entrance panels,
type in the ID code and confirm with the call button.
N.B. (**): If the system already contains an indoor station that has the same associated identification code (ID),
the outdoor station emits a lower tone beep and the operation will have to be repeated.
To Next Page
Loading...
Need help?
General
