15
7509 - 7509/D Tab
EN
Conguration procedure in “Standard” mode
1. Lift the handset and bring it to your ear.
2. Press the
and buttons simultaneously and hold them down until the button starts flashing.
3. Release the buttons.
4. Press buttons
and simultaneously and hold them down (for 2 s) until the handset emits an audible signal
and communication between the entryphone and the outdoor station begins.
5. Release buttons
and .
Caution: you will have 5s in which to press buttons
and (as indicated in step 4). If 5 s pass without pressing
keys and , the procedure in steps 1,2,3 must be repeated.
6. Press the button on the MASTER outdoor station you wish to receive the call from. (*)
7. The ID code is associated with the indoor station and communication is ended. An acoustic signal conrms the
operation was successful. (**)
Caution: when configuring the primary and secondary ID, the entryphones being configured automatically acquire a
code that depends on the association with the call button or code used to call the outdoor entrance panel.
Example: If ID = 8 is given to a second entryphone, the automatic second entryphone identification attribution
procedure will automatically assume ID = 72 (73 or 74 if 72 and / or 73 already exist).
When a call is made to ID = 8 all the indoor stations in the group will ring and you will be able to answer from any one
of them. If, on the other hand, you enter 72 (in the case of an alphanumerical entrance panel) which corresponds to
the ID assigned automatically by the procedure, a ringtone is emitted by the entryphone for which the secondary ID
assignation procedure was carried out and only this entryphone can be used to answer the call.
N.B.: to delete from a group, the conguration deletion procedure described in the “Default data restore procedure”
section must be performed.
To Next Page
Loading...
Need help?
General
