44
Contents
Previous
Page
First
Page
Next
Page
Previous
View
14.6 Referring to Fig 6.9, fit steering chain (23) and joining link (24).
14.7 Slacken clamp bolt (26).
14.8 Ascertain wheel position (set of wheels under change-over gear).
14.9 Align steering ring indicators to the wheel position.
14.10 Tighten clamping bolt (26).
14.11 Referring to Fig 6.14, refit change-over gear cover (9).
Column bearings
15 To install column bearings:
15.1 Before refitting column bearings to a tube set all the adjustable bearings on that tube to minimum
setting.
15.2 Fit bearing assembly into place and secure with four countersunk socket headed screws.
15.3 Adjust bearings (Section 4).
Other replacements
16 All other replacements are simple and the method is self-evident after a brief study of the particular item
and the exploded drawing in Section 6. Replacements affecting wheels or steering chains are equally simple
but require a check on tracking and chain tensioning (Section 4).
NOTE: When fitting a crab/steer pin circlip, shim as necessary to allow 1/32in. clearance between
circlip and clutch body.
If the steering change-over gear (Fig 6.10) has been dismantled, secure items (48) and (50)
with Loctite 221 during assembly.
To Next Page
Loading...
