VIPA System 300V - Page 70

Chapter 4 Deployment CPU 31x Manual VIPA System 300V
4-18 HB130E - CPU - Rev. 11/50
Besides of the transfer via MPI res. MMC you may configure the CPU via
the CP portion when using the CPU 31xNET.
Here all block functions are supported like e.g. load, alter, monitor and
save blocks.
All "PLC" functions except of "Hardware diagnosis" are available.
Up to 64 participants may access simultaneously.
Preconditions
The following software packages are installed:
- SIMATIC manager from Siemens V.5.1 or V.5.2 with SP1
- SIMATIC NET
Approach
•
Start the SIMATIC manager from Siemens, load your project and select
the wanted interface for the online driver under
Options > PG/PC
Interface
.
• Choose an interface parameterization that refers to your network PCI card
like e.g.:
TCP/IP->3Com EtherLink 10/100 PCI
• Transfer the wanted blocks and system data via the PLC functions into
your CPU.
More detailed information is to be found at chapter "Deployment CPU 31x
with TCP/IP" at "PG/OP communication".
Transfer via
Ethernet