Chapter 5 Deployment CPU 31x with Profibus Manual VIPA System 300V
5-4 HB130E - CPU - Rev. 11/50
Now the project engineering of your Profibus DP master is finished. Please
link up now your DP slaves with periphery to your DP master.
• For the project engineering of Profibus DP slaves you search the
concerning Profibus DP slave in the hardware catalog and drag&drop it
in the subnet of your master.
• Assign a valid Profibus address to the DP slave.
• Link up the modules of your DP slave system in the plugged sequence
and add the addresses that should be used by the modules.
• If needed, parameterize the modules.
Note!
If you deploy an IM153 from Siemens with a VIPA CPU 31xDPM, please
use the "compatible" DP slave modules.
These are listed in the hardware catalog at PROFIBUS DP/
Additional Field Devices/Compatible Profibus DP-Slaves.
Starting with the CPU firmware 3.4.0, you may deploy your DP master also
as DP slave. The approach is described on the following page at Project
engineering of the CPU with integrated Profibus slave".
Details about project transfer can be found at chapter "Deployment CPU
31x" at "Project transfer".
Slave operation
with firmware
3.4.0 or higher
Transfer project
To Next Page
Loading...
