Manual VIPA System 300V Chapter 5 Deployment CPU 31x with Profibus
HB130E - CPU - Rev. 11/50 5-9
Note!
To connect this plug, please use the standard Profibus cable type A
(EN50170). Starting with release 5 you also can use highly flexible bus
cable: Lapp Kabel order no.: 2170222, 2170822, 2170322.
Under the order no. 905-6AA00 VIPA offers the "EasyStrip" de-isolating
tool, that makes the connection of the EasyConn much easier.
11 6
Dimensions in mm
The "EasyConn" bus connector is provided with a switch that is used to
activate a terminating resistor.
Attention!
The terminating resistor is only effective, if the connector
is installed at a slave and the slave is connected to a
power supply.
Note!
A complete description of installation and deployment of
the terminating resistors is delivered with the connector.
• Loosen the screw.
• Lift contact-cover.
• Insert both wires into the ducts provided
(watch for the correct line color as below!)
• Please take care not to cause a short
circuit between screen and data lines!
• Close the contact cover.
• Tighten screw
(max. tightening torque 4Nm).
The green line must be connected to A, the red line to B!
Termination with
"EasyConn"
Assembly
Please note:
To Next Page
Loading...
