20
© 2016 Directed. All rights reserved.
Remote Pairing Mode
The following instructions step you through the remote pairing opera-
tion of the Responder LE 2-way or 1-way companion remote control.
Prepare the vehicle system for pairing:
1. Turn the key to the ON position.
2. Within five seconds press and release the Control Center button
one time.
3. Within five seconds, press and hold the Control Center button.
The status LED will flash one time and the horn (if connected)
honks once to confirm the system is ready for remote pairing.
4. Release the Control Center button and proceed to next step.
Prepare the remote control for pairing:
5. Enter programming by pressing and holding the
button for one second, three transmit LED
flashes indicate the remote control is ready to pair.
7. Press the
button.
8. Wait several seconds as the remote generates a security encryp-
tion and sends it to the Control Center. The horn honks and the LE
2-way remote emits several tones to indicate Pairing is complete
(there is no audible confirmation with the 1-way).
If pairing is not successful press and release the
button once
and then repeat steps 6 and 7.
Pairing will exit if:
• Step 7 is not completed within 60 seconds
• The doors are closed
• The ignition is turned off.
To Next Page
Loading...
Need help?
General
