26
© 2016 Directed. All rights reserved.
Turbo Timer Mode
The system keeps the engine running for the Turbo Timer runtime and
can be activated by remote control or optional dash mounted activa-
tion button.
1. With the engine running, set the parking brake.
2. Press the optional dash mounted activation button or perform the
Timer Mode command.
3. The parking lights turn on and the remote start activates the igni-
tion outputs.
4. Turn Off and remove the key from the ignition switch, the engine
remains running.
5. Exit the vehicle, close all the doors and lock the system.
6. The engine runs for the Turbo Mode runtime.
Note
Turbo Timer must be turned on by an authorized Directed
dealer.
For Turbo Timer mode on manual transmission vehicles fol-
low the directions in the Manual Transmission Start (MTS
mode) section with the door open and in step 3 send the
Timer Mode command from the remote control.
Remote Start Faults
For user safety, the system must be properly configured or remote start
will not activate. A Remote Start Fault may be caused by any of sev-
eral configuration issues. If the remote start fails to activate ,refer to the
table below for the command type and parking light flashes that will
identify the configuration issue and solution.
To Next Page
Loading...
Need help?
General
