34
© 2016 Directed. All rights reserved.
34
• Turn Beeps off: The Button beeps can be turned off in the Setup
Remote menu. The command beeps still play normally.
* The optional horn honk feature must be installed. If confirmation honks are
programmed off, the system still emits one honk as an alert when unlocking.
Battery Replacement
LE 2-way remote control
1. Unscrew the hardware on unit rear and remove from housing. Pry
open the housing, this releases all parts of the assembly.
2. Gently slide out the used battery to remove it from the holder.
Orient the new battery for the correct polarity and insert under
clip in holder.
3. Reassemble unit and secure with hardware.
1-way remote control
1. If present, remove the small screw on the back of the remote.
2. Use a small flat blade screwdriver and insert it into the slot locat-
ed along the bottom of the remote, near the key ring. Carefully
pry open the case.
3. Gently slide out the used battery to remove it from the holding
clip. Orient the new battery for the correct polarity and insert
into holding clip.
4. Reposition case parts, and snap together by pressing firmly and
evenly on the front and back. Reinstall screw (if applicable).
Battery Disposal
Directed cares about the environment. If you need to dis-
pose of the battery, please do so in accordance with your
municipal requirements for battery disposal.
To Next Page
Loading...
Need help?
General
