Need help?Do you have a question about the Viper 600 ESP and is the answer not in the manual?
Instructions on concealing the starter kill relay for security.
Methods for locating and connecting a constant 12V power source.
Procedure to identify the vehicle's 12V switched ignition wire.
Step-by-step guide to locating the ignition wire using a multimeter.
Process for identifying the vehicle's starter wire for connection.
Locating the door pin switch wires for system input.
Using a multimeter to test and find the door trigger wire.
Connecting the H1/1 ORANGE wire for ground-when-armed output.
Connecting the H1/2 WHITE wire for light flash output.
Connecting the H1/3 WHITE/BLUE wire for channel 3 output.
Connecting H1/4 BLACK/WHITE for domelight supervision output.
Connecting the H1/5 GREEN wire for negative door trigger input.
Connecting the H1/6 BLUE wire for instant trigger inputs.
Connecting the H1/7 VIOLET wire for positive door trigger input.
Connecting the H1/8 BLACK wire to chassis ground.
Connecting the H1/9 YELLOW wire to the ignition input.
Connecting the H1/10 BROWN wire to the siren output.
To Next Page
General
