38
©
2005
Directed Electronics, Inc. all rights reserved
2-12 BONNET TRIGGER NORMALLY CLOSED/NORMALLY OPEN:
To program the unit
for either a normally closed or normally open pin switch connected to the H1/6 GREY wire.
2-13 DUAL SENSOR TRIGGER ON/OFF:
When programmed On any two sensors (zones 2, 4,
7) need to be triggered within 1-second of each other to trigger the alarm/siren. When programmed
Off each sensor will trigger the alarm/siren independently.
2-14 HIGH SECURITY DISARM ON/OFF:
When programmed On if the alarm is sounding the
system will silence the siren on the first press of the unlock button and disarm/unlock on the second
press of the unlock button. When programmed Off (or within 5-seconds of alarm triggering when
programmed On) the system will disarm and unlock on the first press of the unlock button.
Menu #3 - Advanced Features
3-1 HORN (PULSED)/HORN (CONSTANT):
Program for either a pulsed output or a
continuous output when the alarm is triggered.
3-2 HORN FUNCTION (FULL ALARM ONLY)/SIREN FUNCTION (20mS, 30mS, 40mS,
50mS):
Program the horn honk output to activate when the alarm is fully triggered only or as an
additional siren (arming/disarming warnaway and full trigger with timing option chirps).
3-3 FACTORY DISARM WITH CHANNEL 2 (ON)/FACTORY DISARM WITH CHANNEL
2 (OFF):
The factory alarm disarm wire sends out a pulse when activating channel 2 output.
3-4 GROUND WHEN ARMED IN VALET (ON)/GROUND WHEN ARMED IN VALET
(OFF):
Provides On/Off programming for the Ground When Armed wire output when locking the
car while in Valet mode.
3-5 CHANNEL 3 VALIDITY, LATCHED, LATCHED/RESET WITH IGNITION/30-
SECOND/60-SECOND/90-SECOND TIMED/REMOTE START REPORT:
Channel 3 can
be programmed for these output configurations. The unit is set to the default validity output. To
change the configuration, use the two-chirp setting to toggle to the different configurations listed
below.
➤➤
VVaalliiddiittyy::
Output that will send a signal as long as the transmission is received.
➤➤
LLaattcchheedd::
Output that will send a signal when the Channel 3 button(s) is pressed and will
continue until the same button(s) is pressed again.
To Next Page
Loading...
