©
2005
Directed Electronics, Inc. all rights reserved
49
The system will not arm or disarm
➤
Make sure the ignition is not turned on or that the ignition input wire does not have 12volts.
➤
Make sure the systems 15 amp main fuse has been installed or is not blown.
➤
Make sure the external receiver has been plugged into the main control module correctly.
The Valet switch does not work
➤
Make sure that it is plugged in. (See the Plug-In Harness section of this guide.)
➤
Check the System Features Learn Routine for the default PIN code.
➤
Has the PIN code been changed?
The status LED does not work
➤
Make sure that it is plugged in. (See the Plug-In Harness section of this guide.)
Closing the door triggers the system, but opening the door does not.
➤
Have you correctly identified the type of door switch system? This happens often when the
wrong door input has been used.
System will not passively arm until it is remotely armed and then
disarmed
➤
Are the door inputs connected? Is a BLUE H1/4 wire connected to the door trigger wire in the
vehicle? Either the GREEN H1/3 or the VIOLET H1/5 should be used instead.
To Next Page
Loading...
