26 © 2000 Directed Electronics, Inc. Vista, CA
3. Select the receiver channel. Press and release the Valet/Program switch the number of
times necessary to access the desired channel. Once you have selected a channel, press
and HOLD the Valet/Program switch once more. The siren will chirp and the LED will blink
the number of times corresponding to the channel that has been accessed.
NOTE: If adding a remote to the system, a remote button must be taught to the unit in the Channel 1
or Channel 5 position prior to programming other channels, unless using one of the Auto Learn routines.
Channels Five, Six and Seven: Channels Five through Seven are used to assign the arm, disarm and panic func-
tions to separate buttons on the remote control. If the remote is programmed for separate arm, disarm and panic
channels and a button from that remote is entered into Channel One, the remote will be erased from memory,
and the system will only recognize the button that was entered into Channel One.
Channel Ten: If any transmitter button from a known transmitter is programmed to Channel Ten, all transmitters
will be erased from memory. This is useful in cases when one of the customer's transmitters is lost or stolen. This
will erase any lost or stolen transmitters from the system's memory. It can also be used to start from scratch if
the transmitter buttons were programmed incorrectly.
4. Press the transmitter button. While HOLDING the Valet/Program switch, press the button
from the transmitter that you wish to assign to that channel. The unit will chirp indicat-
ing successful programming. It is not possible to teach a transmitter button to the system
more than once.
5. Release. Once the code is learned, the Valet/Program button can be released.
CHANNEL NUMBER FUNCTION
1 Arm/Disarm/Panic
2 Channel 2 output
3 Channel 3 output
4 Channel 4 output
5 Arm only
6 Disarm only
7 Panic only
8 Auto Learn separate arm/disarm/panic (Standard Configuration*)
9 Auto Learn single-button arm/disarm/panic (Single-Button Arm/Disarm/Panic Configuration*)
10 Delete all transmitters
*NOTE: For Auto Learn Configurations, see Transmitter Configurations section of this guide.
To Next Page
Loading...
