© 2000 Directed Electronics, Inc. Vista, CA 27
You can advance from one channel to another by releasing the Valet/Program switch and tapping it to advance
channels and then HOLDING it. For example, if you want to program Channel Three after programming Channel One,
release the Valet/Program switch. Press it twice and release it to advance to Channel Three. Then press it once
more and HOLD it. The siren will chirp three times to confirm it is ready to receive the code from the transmitter.
The learn routine will be exited if any of the following occurs:
■ Ignition is turned off.
■ Door is closed.
■ Valet
®
/Program switch is pressed too many times.
■ More than 15 seconds elapses between steps.
One long chirp indicates that the learn routine has been exited.
transmitter configurations
The transmitters can be programmed with the standard or single button arm/disarm/panic configurations by using
the Auto Learn functions in the Transmitter/Receiver Learn Routine.
A remote that uses the standard configuration operates similarly to many factory keyless entry remotes. A stan-
dard configuration transmitter allows arming, disarming, and Panic Mode activation with separate buttons. When
programmed for standard configuration, the transmitter buttons are assigned to the following functions:
.....................................operates...........................Arm only
...................................operates...........................Disarm only
..................................operates...........................Channel 2
...................................operates...........................Panic
and ......................operate............................Channel 3
and ...................operate ..........................Channel 4
The standard configuration also allows the user to utilize Multi-Level Security Arming (described in the following
section), a feature that cannot be accessed from a single button arm/disarm/panic configuration transmitter.
standard configuration
To Next Page
Loading...
