30 © 2000 Directed Electronics, Inc. Vista, CA
NOTE: Features 2-9 and 2-10 each have more than two possible settings. Pressing the disarm button
on the transmitter will toggle through all the possible settings.
6. Release the Valet/Program switch. You can either wait 15 seconds to exit the learn
routine, or you can access another feature by following the steps outlined in the following
paragraph.
To access another feature in the same menu:
1. Press and release the Valet/Program switch the number of times necessary to advance from the feature you
just programmed to the next one you want to program.
2. Then press the Valet/Program switch once more and HOLD it.
For example, if you just programmed the third feature in the menu and you would like to program the seventh
feature in the menu, you would press and release the Valet/Program switch four times and then press it once more
and HOLD it. The siren would chirp seven times to confirm access to the seventh feature.
To select another menu:
1. Press and HOLD the Valet/Program switch.
2. After three seconds, the unit will advance to the next menu and the siren will chirp, indicating which menu
has been accessed.
For instance, if you just programmed some features in Menu #1 (Basic Features) and you want to program a
feature in Menu #2, you must press and HOLD the Valet/Program switch. After three seconds, the siren chirps
twice indicating access to Menu #2.
To exit learn routine:
To exit the System Features Learn Routine, do one of the following:
■ Close the open door.
■ Turn the ignition on.
■ No activity for longer than 15 seconds.
■ Press the Valet/Program switch too many times.
To Next Page
Loading...
