34 © 2000 Directed Electronics, Inc. Vista, CA
2-4 PROGRESSIVE DOOR TRIGGER ON/OFF: When this feature is on, the system responds to a door trigger input
with a progressive response. When the door is opened with the system armed, the siren will chirp 10 times prior
to the full triggered sequence. The door trigger is still treated as an instant trigger and closing the door quickly
will not prevent a full triggered sequence from occurring. If the progressive door trigger is programmed off, the
full siren output will occur the moment the door is opened.
2-5 DOOR TRIGGER ERROR CHIRP ON/OFF: With the door trigger error chirp programmed off, the system will not
report an invalid zone on arming when the door trigger wire is active. This eliminates the extra chirps that occur
when interfacing with vehicles that have exceptionally long dome light delay circuits.
2-6 IGNITION-CONTROLLED DOMELIGHT SUPERVISION ON/OFF: If turned on, the system will turn on the dome-
light for 30 seconds when the ignition is turned off. The optional domelight supervision feature must be installed.
2-7 DISARM WITH CHANNEL TWO OFF/ON: If this feature is programmed on, the security system will disarm
whenever Channel 2 is activated with the remote transmitter. This is useful if Channel 2 is used for trunk release.
When the trunk is opened with the remote transmitter, the system will disarm, preventing the security system
from triggering.
2-8 SINGLE/DOUBLE PULSE UNLOCK: Some vehicles require two pulses on a single wire to unlock the doors.
When the double pulse unlock feature is turned on, the BLUE/BLACK H3/5 wire will supply two pulses instead of
a single pulse. This makes it possible to directly interface with double pulse vehicles without any extra parts.
2-9 CHANNEL 3 VALIDITY/LATCHED/LATCHED RESET WITH IGNITION/30 SECOND TIMED/SECOND UNLOCK
OUTPUT: Channel 3 can be programmed for these different output configurations. The unit is set to the default
validity output. To change the configuration, use the disarm button on the transmitter to toggle between the
different configurations.
2-10: CHANNEL 4 VALIDITY/LATCHED/LATCHED RESET WITH IGNITION/30 SECOND TIMED/60 SECOND
TIMED/90 SECOND TIMED: Channel 4 can be programmed for these different output configurations. The unit is
set to the default validity output. To change the configuration, use the disarm button on the transmitter to
toggle between the different configurations.
To Next Page
Loading...
