Vision Engineering EVO Cam II - Stand Mounts; Ergo Stand; Polarisation Filter (Option); Multi-Axis Stand

11
ASSEMBLY
Stand mounts
Ergo stand
` Locate EVO Cam II
u
on to the stand’s dovetail interface
v
.
` Tighten securing grub screw
w
with HEX key provided
Polarisation lter (option)
Please contact Vision Engineering to have polariser tted into the unit by an authorised engineer.
Multi-axis stand
` Place focus assembly
u
on the mounting post
v
so that the locator pin is located in the locator
pin recess
w
.
To change the camera rotation, remove the locator pin from the focus assembly before attaching
it to the mounting post and attach the focus assembly in the desired orientation.
Take care when mounting EVO Cam II.
` Ensure the mounting plate is perpendicular to the base or work bench. Tighten the 2x grub screws
x
at the top of the focus assembly and the 2x grub screws
y
at the bottom of the focus assembly.
` Locate EVO Cam II
u
on to the stand’s dovetail interface
v
.
` Tighten securing grub screw
w
with HEX key provided
` Secure the cable retaining clip
x
under the knuckle of the multi-axis stand using the screw
y
provided. The clip can be secured to the left or right side.
v
w
u
v
w
u
y
x
w
u
v
y
x
Exit
Contents
Preface
Assembly
Operation
Maintenance
Specication
System Diagram
Start page