General
Safety
Before using your system for the rst time, please read the
Health & safety section of the user guide.
Ensure that:
Your system and accessories are operated, maintained
and repaired by authorised and trained personnel only.
All operators have read, understood and observe the user
manual, in particular the safety regulations.
Cleaning
Disconnect your system from the electrical source before
cleaning.
Do not use any unsuitable cleaning agents, chemicals or
techniques for cleaning.
Never use chemicals to clean coloured surfaces or
accessories with rubberised parts.
Use a specialist lens cloth to clean optical surfaces.
Servicing
Repairs may only be carried out by Vision Engineering-
trained service personnel. Only original Vision Engineering
spare parts may be used.
Symbols used
Warning!
A potential risk of danger exists. Failure to comply can
cause i) a hazard to personnel; ii) instrument malfunction
and damage. Please consult the operating instructions
provided with the product.
Warning of electrical shock hazard
This symbol indicates the presence of electric shock hazards.
Please consult the operating instructions provided with the
product.
Important information
This symbol indicates important information. Please
carefully follow the instructions or guidelines.
Health & safety
Unauthorised alterations to the instrument or
non-compliant use shall invalidate all rights to any
warranty claims.
Electrical safety
Disconnect your system from the electrical source before
undertaking any maintenance.
Avoid using any form of liquid near the system.
Do not operate your system with wet hands.
Illumination safety
Do not look directly at the illuminated LED’s. This may
cause damage to the eyesight.
Environmental considerations
Avoid large temperature uctuations, direct sunlight and
vibrations.
Ensure electrical components are at least 10cm from walls
and combustible materials.
Position the system on a rm, rigid and level table.
The equipment should be positioned so that access to the
electrical input connector is always available.
Avoid positioning your system where bright reections
may affect the image.
Operator wellbeing
The advanced ergonomic design and construction of
Vision Engineering products are intended to deliver
superior ergonomic performance, reducing the exertion
of the user to a minimum. Depending on the duration
of uninterrupted work, appropriate measures should
be taken to sustain optimal operator performance.
This could include: Optimal arrangement of workplace;
Variation in task activity; Training of personnel on
workplace ergonomics and general health and safety
principles.
It is important to set-up and optimise your working
environment correctly in order to obtain maximum benet
from the advanced ergonomic design of your system. For
more information visit: www.visioneng.com/ergonomics
Compliance statements
Vision Engineering and its products conforms to the requirements
of the EC Directives on Waste Electrical and Electronic Equipment
(WEEE) and Restriction of Hazardous Substances (RoHS).
All Vision Engineering products conform to the CE mark,
demonstrating that each product meets the requirements
of the applicable EC directives. Where applicable, other
characteristics of the CE directive are implied such as
essential health and safety requirements from all the
directives that applies to its product, including low voltage
directive and the EMC directive.
To Next Page
Loading...
Need help?
General
