Vision VE-810 User Manual

Chapter 3 - Operations 43
Engraving a job at a position other than the top left
corner of the t-slot
If you would like to put your material to be engraved at a position other than the standard
home position, place your material on the t-slot table in the position you desire. Use the
XY jog buttons to move the spindle to the upper left corner of the piece you would like to
engrave. Now press the SET OFFSET button. The machine will now engrave from that
position.
Note: The machine will engrave from that point until the machine is turned off or you clear
the offset. To clear the offset press the GOTO HOME button. After the machine has
moved to the home position, press SET OFFSET. The home is now set back to the
default position.

Vision VE-810 Specifications

General

Brand	Vision
Model	VE-810
Category	Engraver
Language	English