4. System Status and Indications
14 D-304269 KP-250 PG2 User’s Guide
4
4
4
4.
..
. System Status and Indications
S
ystem Status and IndicationsSystem Status and Indications
System Status and Indications
Note: The icons and numbers shown on the above keypad drawing are for illustrative purposes only.
When executing a command, the KP-250 PG2 keypad's LED blinks red once to indicate transmission of the command
to the control panel. If the operation is successfully completed, the green LED lights momentarily and a "happy tune"
sounds. If the operation fails or cannot be completed, for example, when the system is "Not Ready", the red LED
lights steadily and a "sad tune" sounds.
LCD Display and General Audible Indicators
The display is in two lines and is used to display system status a
nd events, time and date, programming instructions
and also an event log file
The sounds you will hear while using the system are:
Sound Definition
Single beep, heard whenever a key is pressed
Double beep, indicates automatic return to the normal operating mode (by timeout).
Three beeps, indicates a trouble event
♫☺
Happy Tune (- - - –––), indicates successful completion of an operation.
♫
Sad Tune (–––––), indicates a wrong move or rejection
Arming Indications
The table below lists the Arming indication keys and their definition.
Icon/Key Indications Arming Indication
ARM AWAY
ARM HOME
DISARM
The icons appear consecutively
EXIT DELAY
To Next Page
Loading...
