Visonic KP-250 - Programming the Scheduler

6. System Configuration
44 D-304269 KP-250 PG2 User’s Guide
B.14 Programming the Scheduler
The PowerMaster system includes a PGM output that can be u
sed
to open and close an electrically-controlled gate, or
to control a preferred electrical device via keyfobs or according to a programmable weekly time schedule.
♦ Here you can schedule the PGM output for up to 4 different ON/OFF time activations per any desired day or days
of the week. In addition, you can schedule a "Daily" schedule that applies to every day of the week. It is
recommended to complete the Scheduler table (placed at the end of this section) before programming the
Scheduler.

Carefully read the section titled "Additional Information" according to the indicated references
1
etc – see table
at end of this section.
A. To Select the Device No.
1.
SCHEDULER
Enter the [USER SETTINGS] menu, select the [SCHEDULER] option and press
.
1
2.
PGM
When the display reads [PGM], press .
B. To Set the Day
2
SUNDAY
The 1
st
day of the scheduler is displayed.
3.
or
Click the
or button until the display reads the day you wish to schedule
or "Daily", for example, "Tuesday".
2
TUESDAY
4.
When the "day" to schedule appears on the display, press .
C. To Select the Activation No.
5.
Operation No 1
The 1
st
operation (PGM output activation) of the scheduler is displayed.
3
or
Click the or button until the display reads the operation you wish to
schedule, for example, "operation No 3".
Operation No 3
6.
When the "operation No." to schedule appears on the display, press .
D. To Set the ON (Start) Time
7.
Start time HH:MM
−
−−
− −
−−
−:−
−−
− −
−−
−
The "start time" screen is shown on the display.
4
To set the start time of the selected operation, press the button.