Visonic KP-250 - Periodic Test Per Partition

8. Periodic Test by User Code
D-304269 KP-250 PG2 User’s Guide 55
Periodic Test per Partition
In addition to the regular Periodic Test, you can also t
est
zones for enrolled sensors (excluding temperature sensors
and sirens) that are assigned to a selected partition.
To conduct the periodic Test per Partition
1
1.
HH:MM READY
TROUBLE
Make sure the selected partition is disarmed and the other partitions are not in exit
or entry delay and then press the partition (
) button.
2.
SELECT PARTITION When the display reads [SELECT PARTITION], press the partition number of the
zones you wish to test, for example, (Partition 1).
3.
PARTITION 1
N.RDY MEMORY
PARTITION 1
N.RDY TROUBLE
4.
Press the button repeatedly until the display reads [PERIODIC TEST] and press
.
PERIODIC TEST
5.
PRESENT TAG OR
ENTER CODE
The screen will now prompt you to or enter your Master user code.
2
6.
Enter Master user
code
P1 SENSORS TEST
3
7.
8. NOT ACTIVE NNN
The display reads [NOT ACTIVE NNN]. NNN indicates the number of enrolled
devices in the panel that have not been tested yet. This number automatically drops
one count for every tested device.
Test per partition is performed by activating each device as explained in point 4 in
the Additional Information table below.
After a device has been activated, the control panel reads [Zxx IS ACTIVATED]
and the "N" indicator drops one count.
After all devices have been tested, the control panel reads [DEVICE TESTS END].
↓
↓↓
↓
DEVICE TESTS END